Assembly site requirements for hydraulic cylinder:
1. The hydraulic cylinder assembly should be carried out in a special workshop or assembly area. The temperature should be kept at 20~250C, and it should be kept away from air vents, dust, and cutting processing areas, with fresh air, no dust, and no noise; avoid direct exposure to strong light.
2. The hydraulic cylinder assembly room should be equipped with an installation platform and sufficient workstation equipment, assembly turnover vehicles, hoisting and lifting equipment and the following special basic equipment.
a: Install Hydraulic cylinder machine;
b: Additional hydraulic cylinder cleaning machine, used for heating and cleaning the other parts;
c: Pressure test equipment, used for hydraulic cylinder pressure test;
d: Air duct, used to blow clean and dry parts after cleaning;
3. The hydraulic cylinder workshop should be equipped with an assembly workbench, and oil-resistant rubber or aluminum plates should be laid on the table to avoid collisions and scratches on the other parts, and the other parts should be equipped with a mounting frame or a mounting basket.
4. In addition to the common tools, the hydraulic cylinder workshop should be equipped with some special tools such as torque wrench, plumb or copper hammer, copper rod, nylon rod, electric cooker, air gun, etc.5. Try to use hoisting belts for hydraulic cylinder assembly room hoisting, instead of using wire rope or hemp rope. The former is easy to damage the parts or appliances, and the latter is easy to produce wire debris that affects the cleanliness of the parts.
6. Special attention should be paid to civilized production, orderly work, civilized operation, and orderly stacking. The ground is cleaned and often washed with waste oil to maintain the original color of the ground.
